1. Failure to comply with Equipment or Angling Regulations.

    2. The act of persons other than the angler touching any part of the rod, reel or line, either bodily or with any device, during the playing of the fish, or in giving any aid other than that allowed in the rules and regulations. If an obstacle to the passage of the line through the rod guides has to be removed from the line, then the obstacle shall be held and cut free. Under no circumstances should the line be held or touched by anyone other than the angler during this process.

    3. Resting the rod on any part of the boat, or on any other object, while playing the fish.

    4. Handlining or using handline or rope attached in any manner to the angler’s line or leader for the purposes of holding or lifting the fish.

    5. Intentionally foul-hooking or snagging a fish.

    6. Shooting, harpooning or lancing any fish (including sharks) at any stage of the catch.

    7. Berleying with flesh, blood, skin or any part of mammals.

    8. Using a boat or device to beach or drive a fish into shallow water in order to deprive the fish of its normal ability to swim.

    9. Attaching the angler’s line or leader to part of a boat or other object for the purpose of holding or lifting the fish.

    10. If a fish escapes before gaffing or netting and is recaptured by any method other than as outlined in the angling rules.

    11. Holding or touching an angler in a manner that assists them in fighting the fish or takes pressure off the angler. Touching or briefly holding the angler to prevent them from falling does not constitute a disqualification.




    1. When a rod breaks (while the fish is being played) in a manner that reduces its length below minimum dimensions or severely impairs its angling characteristics.
    2. When a fish is hooked or entangled on more than one line.
    3. Mutilation to the fish, prior to landing or boating the catch, caused by sharks, other fish, mammals or propellers that remove or penetrate the flesh. (Injuries caused by leader or line, scratches, old healed scars or regeneration deformities are not considered to be disqualifying injuries.) Any mutilation of the fish must be shown in a photograph and fully explained in a separate report accompanying the record application.
    1. The angler must cast, hook, fight and bring the fish to gaff or net unaided by any other person. No other person may touch any part of the tackle during the playing of the fish or give aid other than taking the leader for gaffing or netting purposes. 
    2. Casting and retrieving must be carried out in accordance with normal customs and generally accepted practices. The major criterion in casting is that the weight of the line must carry the lure, rather than the weight of the lure carrying the line. Trolling a lure behind a moving watercraft is not permitted. The craft must be completely out of gear both at the time the fly is presented to the fish and during the retrieve. The maximum amount of line that can be stripped off the reel is 36.57m (120ft) from the lure.
    3. Once a fish is hooked, the tackle may not be altered in any way, with the exception of adding an extension butt.
    4. Fish must be hooked on the lure in use. If a small fish takes the lure and a larger fish swallows the smaller fish, the catch will be disallowed.
    5. One or more people may assist in gaffing or netting the fish.
    6. The Angling and Equipment Regulations shall apply until the fish is weighed.




    (g) Gaffs and nets


    Gaffs and nets used to boat or land a fish must not exceed 2.44m (8ft) in overall length. (When fishing from a bridge, pier or other high stationary structure, this length limitation does not apply.)

    The use of a flying gaff is not permitted. Only a single hook is permitted on any gaff. Harpoon or lance attachments are prohibited.

    A rope or any extension cannot be attached to the gaff.



    (h) 15kg category rules


    1. 15kg tippet is for billfish and sharks only.
    2. Shock tippet length is not to exceed 100cm (1m).
    3. A minimum 500cm of fly line must be used.
    4. Flying gaffs are permitted for this line class only.
    5. All other GFAA rules and regulations for flyfishing apply.


    (c) Rod

    Regardless of material or number of sections, rods must conform to generally accepted flyfishing customs and practices.

    A rod shall not measure less than 1.82m (6ft) in overall length. Any rod that gives the angler an unsporting advantage will be disqualified. Extension butts are limited to 15.24cm (6in).


    (d) Reel

    The reel must be designed expressly for flyfishing. There are no restrictions on gear ratio or type of drag employed, except where the angler would gain an unfair advantage. Electric or electronically operated reels are prohibited.


    (e) Hooks

    A conventional fly may be dressed on a single hook or double hook or two single hooks in tandem. The second hook in any tandem fly must not exceed beyond the wing material. The eyes of the hooks shall be no farther than 15.24cm (6in) apart. Treble hooks are prohibited.



    (f) Lures

    The lure must be a recognised type of artificial fly, which includes streamer, bucktail, tube fly, wet fly, dry fly, nymph, popper and bug. The use of any other type of lure or natural or preserved bait, either singularly or attached to the fly, is expressly prohibited.

    The fact that a lure can be cast with a fly rod is not evidence in itself that it fits the definition of a fly. The use of any lure designed to entangle or foul-hook a fish is prohibited.

    No scent, either natural or artificial, is allowed on flies. The use of scented material in a fly is prohibited.



    (a) Line

    Any type of fly line and backing may be used. The breaking strength of the fly line and backing are not restricted.



    (b) Leader

    Leaders must conform to generally accepted fishing customs.

    The leader includes a class tippet and, optionally, a shock tippet. A butt or taper section between the fly line and the class tippet shall also be considered part of the leader, and there are no limits on its length, material, or strength.


    The class tippet must be made of non-metallic material and either attached directly to the fly or to the shock tippet, if one is used. The class tippet must be at least 38.10cm (15in) long (measured inside connecting knots). With respect to knotless, tapered leaders, the terminal 38.10cm (15in) will also determine tippet class. There are no maximum length limitations. The breaking strength determines the class of the tippet.


    A shock tippet, not to exceed 30.48cm (12in) in length, may be added to the class tippet and tied to the lure. It can be made of any type of material, and there is no limit on its breaking strength. The shock tippet is measured from the eye of the hook to the single strand of class tippet and includes any knots used to connect the shock tippet to the class tippet.


    In the case of the tandem hook fly, the shock tippet shall be measured from the eye of the leading hook.